Store all your “Pelican” and equipment cases up and away! Free up some floor space in your storage area with the CineLift!! Create a remote controlled “lighting grid” for your small studio!
Take it a step further and create a lighting speedrail grid in your studio so you can light from the up in the grid above and keep the floorspace clear. Load up the grid with lights and bring them down and up with the ease of a remote control. Do all this and stil load up the platform with all your cases and gear!
Great for tight storage spaces, small studios and garages. Get all your gear and equipment tucked up and out of the way. Then with the push of a remote control have all the gear lower on the platform. Also adds a bit of security.
Lower the storage platform at the push of a button!
Installation on Joists and Rafters.
Steel aircraft cables (Lift tested to UL-standards)
Built in the USA – Uses SPAX® PowerLags®
Low ceiling hanging height – Competitor’s lifts require 4 ft.
INCLUDES: Motors with cables, Platform, Hardware, Remote, struts, step-by-step instructions
General specs
- Model:Auxx-Lift 1600
- Lifting Capacity:Up to 600 lbs
- Max. Travel Distance1:22 ft
- Min. stored height2:8 in
Roof Support
- Type:(2) 1 5/8″ x 60″ strut channel
- Fasteners:(8) 5/16″ x 4″ SPAX© Lag Bolts
- Mounting Area:5′ x 5′ over 3 joists/rafters
- Cable:3/16” Vinyl-coated Steel 7×19
- Cable Strength3:4,200 lbs
Operating Requirements
- Switch Voltage:110V / 120V
- Transmitter:433.92 MHz
- Electrical Cord:10 FT / 16 gauge / NEMA 5-15
- Min. circuit size:15 amp
Platform Specs
- Thickness:2.5 inches
- Support Frame:C-Channels (15gauge)
- Face material:3 x 3 galv. Wire Mesh (4gauge)
Motors
- Type:IP44 (T-Motor)
- Rated Power:680 W
- Rated Current:6.0 A
- Voltage / Phase:100-120V AC / Single
- Duty Cycle @ Max. Capacity:3 min on, 15 min off4
Size and Weight
- Dimensions:3ft x 6ft, 3ft x 8ft, 4ft x 6ft, 4ft x 8ft
- Weight:128 pounds
